| MRC |
Requirement Statement |
Characteristics |
| TTQY |
TERMINAL TYPE AND QUANTITY |
3 PIN |
| CBBL |
FEATURES PROVIDED |
NONMETALLIC SHAFT |
| AEHT |
CENTER TO CENTER DISTANCE BETWEEN TERMINALS |
0.200 INCHES NOMINAL |
| ABXF |
SHAFT LENGTH |
0.080 INCHES MAXIMUM |
| CRSX |
ACTUATOR TRAVEL CONTROL FEATURE |
CLUTCH |
| CQGN |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER |
175.0 SINGLE SECTION |
| AEFD |
ACTUATOR TYPE |
SINGLE SHAFT |
| ADAU |
BODY HEIGHT |
0.390 INCHES NOMINAL |
| ABWV |
SHAFT DIAMETER |
0.075 INCHES NOMINAL |
| AARG |
RELIABILITY INDICATOR |
NOT ESTABLISHED |
| CSDH |
AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER |
70.0 SINGLE SECTION |
| AXGY |
MOUNTING METHOD |
TERMINAL |
| CRGD |
POWER DISSIPATION RATING PER SECTION IN WATTS |
1.0 FREE AIR SINGLE SECTION |
| CQCK |
ROTARY ACTUATOR TRAVEL IN ANGULAR DEG |
9000.0 NOMINAL |
| ADAT |
BODY WIDTH |
0.145 INCHES NOMINAL |
| CSDL |
STANDARD TAPER CURVE PER SECTION |
A SINGLE SECTION |
| AEFK |
MAXIMUM STARTING TORQUE |
5.00 INCH-OUNCES |
| CRSS |
RESISTANCE TOLERANCE PER SECTION IN PERCENT |
-5.0 TO 5.0 SINGLE SECTION |
| AEDX |
SHAFT STYLE |
ROUND, SLOTTED |
| APXH |
TERMINAL LOCATION |
REAR END |
| ADAQ |
BODY LENGTH |
0.375 INCHES NOMINAL |
| AAQL |
BODY STYLE |
RECTANGULAR W/MOUNTING HOLE/SLOT |
| TEST |
TEST DATA DOCUMENT |
81413-230269 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
| CQCC |
ELECTRICAL RESISTANCE PER SECTION |
500.0 OHMS SINGLE SECTION |
| CQCM |
CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL |
0.100 INCHES NOMINAL |
| AAPN |
SECTION QUANTITY |
1 |
| CRFJ |
TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS |
-50.0 TO 50.0 SINGLE SECTION |
